- How do you mic a bass drum without a hole in it?
- Why do drummers put pillows in bass drum?
- Should I put a pillow in my bass drum?
- How can I improve my drumming skills?
- What does cutting a hole in the bass drum do?
- What is the little drum in front of the bass drum?
- Why do drummers put tape on their drums?
- Why do drummers wear earpieces?
- How often should drum heads be replaced?
- What size bass drum is best?
- Who is the fastest double bass drummer?
- How do you mic a bass drum?
How do you mic a bass drum without a hole in it?
There are a couple of ways you can use a kick drum microphone inside of the drum but in this case, you’re looking at mic’ing the drum without that hole.
The most obvious method is to place the microphone just up to the resonance head as close as possible without getting touched by the drum head when it’s played..
Why do drummers put pillows in bass drum?
A pillow or blanket in the bass drum muffles the overtones. Without muffling the bass drum can sound very “open” which means it can be very resonant. Instead of a punchy “thud” you’ll get a softer and longer “mushy” note in most cases.
Should I put a pillow in my bass drum?
The bass drum will eventually sound dead and flat – not what you want. The trick is to put a small amount of muffling in there. Try placing one pillow or blanket resting on the bottom of the drum. This way you get bit more control of the air flow, as well as the resonance on the drum head without killing the sound.
How can I improve my drumming skills?
10 ways to improve your drumming skills#1: Go back to basics. Drummers often try to run before they can walk, which can lead to bad habits and gaps appearing in their ability. … #2: Supercharge your fitness. … #3: Boost your diet. … #4. … #5: Get out and play. … #6: Practice to a click. … #7: Take it slow. … #8: Watch other drummers.More items…
What does cutting a hole in the bass drum do?
Cutting a port hole in your bass drum changes the sound, and gives you the ability to do a few other things. … With a bass drum port hole (vs. no port hole), you have: Better projection (your bass drum sound will go further).
What is the little drum in front of the bass drum?
The tiny drum in front of the bass drum is actually not a drum at all! That is the Yamaha Subkick bass drum microphone. The subkick is a specialty mic that picks up sub bass frequencies that smaller diaphragm mics simply cannot. Used live, these really help pick up the boominess of the bass drum.
Why do drummers put tape on their drums?
The primary reason why drummers apply tape on the surface of their drum heads is for the reduction of over tones or sustain. Applying tape also allows for better studio recordings and it can help reduce the volume of the drums slightly. This is one of several different solutions for control over tones, however.
Why do drummers wear earpieces?
When a drummer uses a click track, headphones are a necessity, as any other method would mean the crowd will hear the clicks. Drumming headphones are also hearing protection, attenuating at least 20db of sound. … So drummers wear these headphones to lower the drum noises to a much safer level.
How often should drum heads be replaced?
every six monthsThey recommend always changing your drum heads before you start recording. Otherwise, if you’re just practicing and playing normally, you should find yourself replacing heads every six months or so. Six months isn’t a hard rule, and for some could be a risky amount of time to wait.
What size bass drum is best?
20″Bass drums. The 20″ diameter is the most popular, it’s a great all-purpose size. In addition to the portability, the drum has an easy, tight feel, and the sound is sufficient for both pop and jazz. A good basic sound can be found in 14″- 16″ depths.
Who is the fastest double bass drummer?
Tim WatersonTim Waterson is a Canadian drummer who holds the world record for the fastest number of double strokes on a bass drum, with a record of 1,407 in one minute (January 22, 2002).
How do you mic a bass drum?
Place the mic 2 to 3 inches away from the inside head and a couple of inches off center. This is the standard way to mic a kick drum if you have the outside head off or if a hole is cut in it. This placement gives you a sharp attack from the beater hitting the head.